This sealing strip is the first press-in-place caulk strip in high quality. Without any mess and hassle of the traditional caulk, anyone can complete caulking project at home like an expert.
It is a high quality PE extrusion with a high-performance adhesive, can adheres to most surfaces. The kitchen gas stove, sink, bathroom sink, bathtub and the gap between the wall and the edge of the wall and the wall seal can be used.
Unlike other PVC caulk strip products on the market, PE caulk strip sticks are much stronger, mere heat-resistant and waterproof. It acts like a professionally installed traditional caulk bead and adds a barrier to water infiltration.
Linear design, it's can zigzag into 90 degrees right angle, can be attached to the corner lines of the wall Good stickiness, not easy to fall off, no residue left when removed Easy to use, tearing the sticker off the adhesive and sticking it at the slot at the sink.
Stick this sealing strip to prevent the place from going mouldy or black, it can leave you with a clean and tidy surface after a few minutes.
1.Please completely clean the surface and make sure it’s dry, remove any existing silicone caulking prior to installation.
2.Please heat the tape by hair dryer for better stickiness before usage.
3.Apply to any flat and smooth surface such as tile, marble, glass, painted wood and so on.
4.Suggest to install the sealing strip above 25 Celsius Degrees. It will be not paste well if the temperature is too low.
5.Firmly press the strip after installation, and then wait about 8-10 hours to use.
- 1 x 50MM x 5M / 2in x 16ft Waterproof Moldproof Adhesive Tape