Price:
US$15.81

Free Shipping

100A Spot Welding Time DIS Current Controller Module Digital Timing Current Control Panel Board
Feature:
1. The spot welding machine control module is developed for DIY or simple battery welding machine. It is mainly used for welding nickel plated single battery or battery pack.
2. For example, 0.15 mm and 0.2 mm steel plates for 18650 nickel-plated lithium batteries, transformers over 500W can be welded with different battery materials and thickness.
3. For example, polymer battery electrodes cannot be turned to nickel plating. It is necessary to cooperate with enough high-power transformers for welding.
4. The module includes the main board and display board. 100A bidirectional thyristors are optional. It does not include welding transformers, welding pens and other supporting tools.

Application:
Develop and weld DIY or simple battery welding machines.
Soldering of a single battery or battery pack.

Function:
1. You can save the last operation, and Monopulse triggers this module.
2. Voltage compensation, according to local voltage changes, automatically adjust the compensation output, trigger display local voltage and compensation value about 1 second. Keep the effective heat consistent with the same welding parameters.
3. With 0-999 welding counting function, it can save power outage. The number of welding is clear at a glance. Press the encoder for 3 seconds to remove the count.
4. Time input 0-99 cycle (1 cycle 20ms, for example, adjust 50, that is, welding time 1 seconds). The adjustable welding strength is 30%-99%.
5. 99-12V AC power input (need to use AC transformer, other such as DC, may lead to zero-crossing detection failure, can not trigger).
6. Power input and external trigger are convenient and fast, without welding terminals. External trigger diversity, such as various switches, foot switches, external signal input, etc. The software is installed in a lock-proof state, triggered to the end of welding as a circular… For example, the pedal switch is always trampled, triggering only one turn.

Specification:
Size: 105*45*25mm/4.13*1.77*0.98''

Warm Tips:
1. This module DIY requires some electrician knowledge and for those whose are completely unclear. Please refer to electrician knowledge before starting.
2. When installing, pay attention to the electrical safety of high voltage components. When the frequency and power are high, SCR needs the radiator.
3. The power of the module driving load depends on the power of the thyristor rectifier. BAT100 (100A) You can take two microwave oven transformers. It is recommended to use 100A transformer.
4. Without knowing the welding time and power of welding parts, it is suggested that the welding time and power should be from small to high in order to avoid damaging the welding pen.

Causes and Troubleshooting:
1. Local voltage does not match actual voltage: re voltage calibration.
2. Solder joints are not solid or welded. Adjust welding time and power until satisfactory results are achieved.

Note:
Please allow 1-3mm differs due to manual measurement.
Due to the different display and different light, the picture may not show the actual color of the item. Thanks for your understanding.

Package Content:

1 x Spot Welding Time and Current Controller Module

100A Spot Welding Time DIS Current Controller Module Digital Control Panel
100A Spot Welding Time DIS Current Controller Module Digital Control Panel
100A Spot Welding Time DIS Current Controller Module Digital Control Panel
100A Spot Welding Time DIS Current Controller Module Digital Control Panel
100A Spot Welding Time DIS Current Controller Module Digital Control Panel

Leave a Comment